How to join rubber conveyor belt

How to join rubber conveyor belt?

1.  Belt buckle joint: This method is generally suitable for small conveyor belt conveying equipment, with economic benefits, simple operation, fast replacement speed and other characteristics.

   (1). Adjust the length of the conveyor belt buckle to about 5cm narrower than the conveyor belt, fix the conveyor belt buckle on the lower template, and wear the positioning pin.
   

   (2). The conveyor belt embedded into the conveyor belt buckle to the front section of all the bottom of the position, the conveyor belt and conveyor belt buckle to about symmetry.
   

   (3). Nail nails first good central location of a buckle, and then nailed two edge location close to the conveyor belt buckle, bind each conveyor belt buckle, be sure to die on a hand-held bottom button come into contact with the body of the surface, tapping the punch, first make the gusset plate in contact with the conveyor belt, then the punch, and hitting the nail into the fasteners, fastener nail penetrate conveyer belt automatically after bending.

2.   Cold glue joint: This method is suitable for medium conveyor belt conveying equipment, has the characteristics of wide application, easy operation and high joint strength.

       (1). Construction preparation: Before the conveyor belt is cold bonded, the necessary tools should be prepared: cold vulcanized adhesive SK313, cleaning agent SK353, RIT patch strip, wallpaper knife,               ruler, Angle grinder, tungsten steel grinding disc, hair dryer, gasoline, oil resistant gloves, rubber brush, etc. (Cold adhesion has high requirements on the external environment. The temperature and                 humidity of the weather should be moderate to prevent the influence of rain and dew and dust. Before operation, simple tents should be set up, the operating platform should be placed, the conveyor             belt should be fixed, the joint part  should be set aside, and the positive and negative sides of the joint should be paid attention to.)

       (2). Marking and cutting

       (3). Joint polishing and cleaning

       (4). Paste molding and maintenance

3.   Hot vulcanized joint: 

      (1). The hot vulcanizing joint method is to realize the conveyor belt joint by heating and pressurizing the conveyor belt vulcanizing machine.

      (2). This method is suitable for large conveying equipment, is currently a relatively ideal joint method, can make the conveyor belt joint part completely sealed, not affected by            moisture, long service life, stable operation of the conveyor belt.

      (3). Hot vulcanized joint method is often used for steel wire conveyor belt, layered nylon conveyor belt, PVG whole core flame retardant conveyor belt joint.